However, due to the large volume of the equipment and the complex disassembly, it is difficult to master its internal work and damage. At present, the internal work inspection of most equipment is achieved through disassembly and decomposition of the equipment. It consumes a lot of manpower and material resources, and it is easy to cause secondary damage to the equipment.
The hole detection and detection technology is inspected inside the equipment without disintegration to provide a basis for the judgment of faults. It is an important way for the current maintenance inspection of the compressed unit and realizes the internal non -destructive testing of the compressed unit and auxiliary equipment.
What is the Kong scratch instrument? There are three main aspects in the use of compression units:
1. Check the blade blade blade
The rotor blades of the compressor are one of the main components of the gas turbine. The surface of the air pressure machine's blades appears on the surface of the blasting machine, which will cause the airflow of the place where the airflows will not be disturbed. It directly affects the normal operation of the gas turbine.
2. Inspection of the gas turbine burning room
The combustion room is an important heat component of the gas turbine. It is mainly composed of a rotor area, fuel nozzle, flame stabilizer, a diversion ring/rectifier, diffuser, and igniter. Because the temperature of the exit gas of the combustion room directly affects the efficiency of the gas turbine, the pore detection of the gas turbine combustion chamber should be regularly conducted, and the phenomenon of cracks, ablation, material corrosion, and carbon accumulation of the internal structure of the gas turbine combustion chamber should be checked.
3. Examination of imported short section filters
In order to prevent large granular impurities from entering the compressor, causing high -speed rotating impeller blades to damage, generally set the short air inlet section in the imported direct pipe section of large centrifugal compression units, and there is a mesh filter inside. Use hole detection and detection technology to check the blockage and damage of the short section without disassembly, and clean up according to the results of the hole detection.
The Kong Tanzi can not only be used for the inspection of the gas turbine body, but also can be widely used in the inspection of equipment such as valves, heat exchangers, and other equipment. It visually display the fault point condition, providing a strong basis for analysis and judgment.
The above is all the contents of the application in the compression unit inspection. Thank you for your continuous attention to the professional endoscope solution to the service provider-Shenzhen Micro Vehicle Optoelectronics Co., Ltd.!
Industrial borescope
solution service provider
